-Question: with two push button encoders what would be the best button functions to assign for bootloader/firmware upgrade functionality (yes I have read many of the threads concerning this but am still confused)?
Acrylic Sketchup case mockup
3 posts
• Page 1 of 1
Acrylic Sketchup case mockup
by bobsagat666 » Mon Jan 26, 2009 11:13 pm
here is my future case design. It consists of 3/16" green acrylic with mitered joints. The front panel has two push button rotary encoders, power switch, LED activity, midi in/out and the LCD. I am also considering doing this same design in wood instead as it would be easier and could look very nice. Any advice on miter cutting the acrylic and joining it would be helpful.
-Question: with two push button encoders what would be the best button functions to assign for bootloader/firmware upgrade functionality (yes I have read many of the threads concerning this but am still confused)?
-Question: with two push button encoders what would be the best button functions to assign for bootloader/firmware upgrade functionality (yes I have read many of the threads concerning this but am still confused)?
- bobsagat666
- Posts: 10
- Joined: Sat Jan 10, 2009 4:39 am
Re: Acrylic Sketchup case mockup
by dmitri » Tue Jan 27, 2009 12:00 am
bobsagat666 wrote:-Question: with two push button encoders what would be the best button functions to assign for bootloader/firmware upgrade functionality (yes I have read many of the threads concerning this but am still confused)?
It's up to you really. I use the LEFT button with the LEFT/RIGHT encoder and the RIGHT button with the UP/DOWN encoder.
- dmitri
- Site Admin
- Posts: 8715
- Joined: Fri Aug 03, 2007 8:05 pm
Re: Acrylic Sketchup case mockup
by Synthex » Tue Jan 27, 2009 5:20 pm
It's a nice design and a beautiful picture ! 
- Synthex
- Posts: 1471
- Joined: Fri Oct 12, 2007 6:06 am
- Location: France
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests